The narrow lanes of the Blackmore Vale take a hard knock every winter. Between December 2025 and February 2026, during one of the wettest starts to a year in decades, Dorset Council recorded a 92 per cent rise in pothole reports compared with a year earlier, and repaired more than 3,000 potholes in January and February alone. Every pothole sends a jolt through the suspension and steering, and wear in those parts is not always noticeable from the driver’s seat. A dry day and a jack are enough to find out more. The check takes about five minutes per wheel and shows whether a visit to the garage is needed.

● A jack
● Two axle stands
● Wheel chocks
● Gloves
● A torch
● A helper to press the brake pedal and watch the suspension joints
Before the wheel leaves the ground
Before checking a wheel for play or investigating noise from a worn wheel bearing, work on firm, level ground, never on gravel or grass. Apply the handbrake, engage first gear or Park, and place wheel chocks against the wheels on the opposite axle. Only lift the vehicle at the jacking points specified in the owner’s manual, and lower it onto an axle stand before starting work. Never put any part of your body underneath a car supported only by a jack.
1. Raise the wheel until the tyre is a few centimetres clear of the ground.
2. Hold the tyre at the top and bottom, then push and pull firmly in opposite directions. A sound wheel feels solid, while a knock or rocking movement indicates play.
3. Repeat with the hands at the sides of the tyre. On a front wheel this tests the steering, where slight give is normal but a distinct clunk is not.
4. Spin the wheel by hand and listen near the hub. A light brush of the brake pads is normal, whereas a rumble or a gritty feel is not.
5. Ask the helper to hold the brake pedal down and rock the wheel top to bottom again. The brake locks the hub to the disc, so any play that disappears is coming from the bearing.
Each symptom usually points to a particular part, as the table below shows.
| What you notice | Likely cause |
| Top-to-bottom play that disappears with the brake on | Wheel bearing |
| Top-to-bottom play that remains with the brake on | Ball joint or suspension bush |
| Side-to-side clunk on a front wheel | Track rod end or inner tie rod |
| Rumble or roughness when spun | Wheel bearing, or possibly a dragging brake |
Shining a torch on each joint while the wheel is rocked often shows which part is moving.
Where a driveway check reaches its limits
A raised wheel carries no load, and some faults appear only under weight. A worn ball joint can feel tight on a jack, a bearing may hum only at speed, and a worn driveshaft joint usually clicks on full lock instead. Steering and suspension parts are safety-critical, so any play found at home should be confirmed by a garage.
Why a wheel bearing begins to hum
Bearings carry the weight of the car and allow each wheel to turn smoothly under considerable load. A healthy bearing typically lasts around 112,000 miles (180,000km), turning roughly 100 million times over that distance. Noise usually begins when worn seals let in water and grit, or when a heavy impact such as a deep pothole damages the internal races. The sound often grows louder with speed or when cornering in one direction. A short video from AUTODOC shows the typical signs of a failing hub bearing and explains the most common causes. Catching the fault early limits further damage, and knowing the likely replacement cost in advance makes a garage quote easier to judge.


